10-2.3 Status
The section describes when you complete the MLD Snooping and how to display the MLD
Snooping Status and detail information. It will help you to find out the detail information of
MLD Snooping status.
Web Interface
To display the MLD Snooping Status in the web interface:
1. Click Multicast, MLD Snooping, and Status.
2. To automatically refresh the information select “on” at “Auto-refresh”.
3. Click “Refresh” to refresh an entry of the MLD Snooping Status Information.
Figure 10-2.3: MLD Snooping Status
Parameter descriptions:
VLAN ID: The VLAN ID of the entry.
Querier Version: Working Querier Version currently.
Host Version: Working Host Version currently.
Querier Status : Show the Querier status is "ACTIVE" or "IDLE". "DISABLE" denotes the specific
interface is administratively disabled.
Queries Transmitted: The number of Transmitted Queries.
Queries Received: The number of Received Queries.
V1 Reports Received: The number of Received V1 Reports.
V2 Reports Received: The number of Received V2 Reports.
V1 Leaves Received: The number of Received V1 Leaves.
Router Port: Display which ports act as router ports. A router port is a port on the Ethernet switch that
leads towards the Layer 3 multicast device or MLD querier.
Static denotes the specific port is configured to be a router port.
Dynamic denotes the specific port is learnt to be a router port.
Both denote the specific port is configured or learnt to be a router port.
Port: Switch port number.
Status: Indicate whether specific port is a router port or not.
Buttons
Auto-refresh: Check to refresh the page automatically every 3 seconds.
Refresh: Click to refresh the page immediately.
To Next Page
Loading...