10-2.5 MLD SFM Information
Entries in the MLD SFM Information Table are shown on this page. The MLD SFM
(Source-Filtered Multicast) Information Table also contains the SSM (Source-Specific Multicast)
information. This table is sorted first by VLAN ID, then by group, and then by Port.
Different source addresses belong to the same group are treated as single entry.
Web Interface
To display the MLD SFM Information in the web interface:
1. Click Multicast, MLD Snooping, and MLD SFM Information.
2. To auto-refresh the information click Auto-refresh “On”.
3. Click “Refresh” to refresh an entry of the MLD SFM Information.
Figure 10-2.5: MLD SFM Information
Parameter descriptions:
VLAN ID: VLAN ID of the group.
Group: Group address of the group displayed.
Port: Switch port number.
Mode: Indicates the filtering mode maintained per (VLAN ID, port number, Group Address) basis.
It can be either Include or Exclude.
Source Address: The IP Address of the source. Currently, the system limits the total number of IP
source addresses for filtering to be 128.
Type: Indicates the Type. It can be either Allow or Deny.
Show entries: You can choose how many items you want to display.
Buttons
Auto-refresh: Check to refresh the page automatically every 3 seconds.
Refresh: Click to refresh the page immediately.
To Next Page
Loading...