3-2 IP Address
3-2.1 IP Settings
At System > IP Address > IP Settings you can configure the IPv4 address and related parameters.
Web Interface
To configure IP settings in the web interface:
1. Click System, IP Address, IP Settings.
2. Check the “IPv4 DHCP Client Enable” box.
3. Enter the IPv4 Address, Subnet Mask, Gateway, and DNS Server parameters.
4. Click Apply.
Figure 3-2.1: The IP Settings page
Parameter descriptions:
IPv4 DHCP Client Enable: Check the box to enable DHCP Client support globally.
IPv4 Address: e.g., 192.168.1.77.
Subnet Mask: e.g., 255.255.255.0.
Gateway: e.g., 192.168.1.254.
DNS Server: Select either No DNS server, Configured, From this DHCP
interface, or From any DHCP interfaces. If you select “Configured”, enter an IP
address.
If you select “From this DHCP interface”, enter a DNS Server number
(configured in the following section “Advanced IP Settings”.
Buttons
Apply: Click to save changes.
To Next Page
Loading...