12-1.4 Access Management
This section shows you how to configure access management table of the Switch including
HTTP/HTTPS, SNMP, and TELNET/SSH. You can manage the Switch over an Ethernet LAN or
over the Internet.
Web Interface
To configure an Access Management Configuration in the web interface:
1. Click Security,
Management, Access Management.
2. Select “on” in the Mode of Access Management Configuration.
3. Click “Add New Entry”.
4. Checked Access Management method (HTTP/HTTPS, SNMP, and TELNET/SSH) in the
entry.
5. Click Apply.
Figure 12-1.2: Access Management Configuration
Parameter descriptions:
Mode: Indicates the access management mode operation. Possible modes are:
On: Enable access management mode operation.
Off: Disable access management mode operation.
VLAN ID: Indicates the VLAN ID for the access management entry.
Delete: Check to delete the entry. It will be deleted during the next save.
IP address: Enter the source IP address.
Mask Length: Enter the Mask Length (1-30).
HTTP/HTTPS: Indicates that the host can access the switch from HTTP/HTTPS interface if the host IP
address matches the IP address range provided in the entry.
SNMP: Indicates that the host can access the switch from SNMP interface if the host IP address
matches the IP address range provided in the entry.
To Next Page
Loading...