12-4.2 Status
This section shows you an overview/detail of the RADIUS Authentication and Accounting
servers’ status to ensure the function is workable.
Web Interface
To display a RADIUS Status in the web interface:
1. Click Security, RADIUS, and Status.
2. Select a Server line to display the detail statistics for a particular RADIUS server.
Figure 12-4.2: RADIUS Server Status
Parameter descriptions:
RADIUS Authentication Server Status
# : The RADIUS server number. Click to navigate to detailed statistics for this server.
IP Address : The IP address and UDP port number (in <IP Address>:<UDP Port> notation) of this
server.
State : The current state of the server. This field takes one of the following values:
Disabled : The server is disabled.
Not Ready : The server is enabled, but IP communication is not yet up and running.
Ready : The server is enabled, IP communication is up and running, and the RADIUS module is
ready to accept access attempts.
Dead (X seconds left) : Access attempts were made to this server, but it did not reply within the
configured timeout. The server has temporarily been disabled, but will get re-enabled when the
dead-time expires. The number of seconds left before this occurs is displayed in parentheses. This
state is only reachable when more than one server is enabled.
RADIUS Accounting Server Status
# : The RADIUS server number. Click to navigate to detailed statistics for this server.
IP Address : The IP address and UDP port number (in <IP Address>:<UDP Port> notation) of this
server.
To Next Page
Loading...