12.7 Access Control List
The section describes how to configure Access Control List rules. An Access Control List (ACL) is a
sequential list of permit or deny conditions that apply to IP addresses, MAC addresses, or other more
specific criteria. This switch tests ingress packets against the conditions in an ACL one by one. A packet
will be accepted as soon as it matches a permit rule, or dropped as soon as it matches a deny rule. If no
rules match, the frame is accepted. Other actions can also be invoked when a matching packet is found,
including rate limiting, copying matching packets to another port or to the system log, or shutting
down a port. This page shows the Access Control List (ACL), which is made up of the ACEs defined on
this switch. Each row describes the ACE that is defined. The maximum number of ACEs is 256 on each
switch. Click on the lowest plus sign to add a new ACE to the list. The reserved ACEs used for internal
protocol, cannot be edited or deleted, the order sequence cannot be changed the priority is highest.
Navigate to Switch >Access Control List > Access Control List to display the Access Control List
Configuration page:
Click the icon to add an ACE from the ACE Configuration page:
ACE Configuration / Frame Type: Any
To Next Page
Loading...