Transition Networks SM8TAT2SA - LLDP Neighbor

3-5.3 LLDP Neighbor
This page provides a status overview for all LLDP neighbors. The displayed table contains a row
for each port on which an LLDP neighbor is detected.
Web Interface
To show LLDP neighbors:
1. Click System, LLDP, and LLDP Neighbor.
2. Click Refresh for manual update web screen.
3. Click Auto-refresh for auto-update web screen.
Figure 3-5.3: The LLDP Neighbor Information page
N
OTE
: If your network device doesn’t support LLDP the table displays “No LLDP neighbor
information found”.
Parameter descriptions:
Local Port: The port on which the LLDP frame was received.
Chassis ID: The Chassis ID is the identification of the neighbor's LLDP frames.
Port ID: The Remote Port ID is the identification of the neighbor port.
Port Description: Port Description is the port description advertised by the neighbor unit.
System Name: System Name is the name advertised by the neighbor unit.
System Capabilities: System Capabilities describes the neighbor unit's capabilities. The possible
capabilities are:
1. Other
2. Repeater
3. Bridge
4. WLAN Access Point
5. Router
6. Telephone
7. DOCSIS cable device
8. Station only
9. Reserved
When a capability is enabled, the capability is followed by (+). If the capability is disabled, the capability
is followed by (-).
System Description: Displays the system description.
Management Address: Management Address is the neighbor unit's address that is used for higher