Transition Networks SM8TAT2SA - Aggregation Hash Mode

4-5.3 Aggregation Hash Mode
Web Interface
To configure the Aggregation hash mode in the web interface:
1. Click Port Management, Link Aggregation, and Aggregation Hash Mode.
2. Click Hash Code Contributors to select the mode.
3. Click the Apply button to save the setting.
4. To cancel the setting, click the Reset button to previously saved values.
Figure 4-5.3: Aggregation Hash Mode
Parameter descriptions:
Hash Code Contributors
src-mac: The Source MAC address can be used to calculate the destination port for the frame. Check to
enable the use of the Source MAC address, or uncheck to disable. By default, Source MAC Address is
enabled.
dst-mac: The Destination MAC Address can be used to calculate the destination port for the frame.
Check to enable the use of the Destination MAC Address, or uncheck to disable. By default, Destination
MAC Address is disabled.
ip: The IP address can be used to calculate the destination port for the frame. Check to enable the
use of the IP Address, or uncheck to disable. By default, IP Address is enabled.
src-dst-mac: Source MAC Address + Destination MAC Address.
src-ip: Source MAC Address + IP Address.
dst-ip: Destination MAC Address + IP Address.
src-dst-ip: Source MAC Address + Destination MAC Address + IP Address.
Buttons
Apply : Click to save changes.
Reset : Click to undo any changes made locally and revert to previously saved values.