4-5.4 LACP System Priority
This page lets you set the priority part of the LACP system ID. LACP will only aggregate together
the ports whose peer link partners are all on a single system. Each system that supports LACP
will be assigned a globally unique System Identifier for this purpose. A system ID is a 64-bit field
comprising a 48-bit MAC Address and 16-bit priority value. The System Priority is configurable; its
range is 1 - 65535. The default is 32768.
Web Interface
To configure the LACP System Priority in the web interface:
1. Click Port Management, Link Aggregation, and LACP System Priority.
2. Specify the LACP System Priority.
3. Click the Apply button to save the setting.
4. To cancel the setting click the Reset button to revert to previously saved values.
Figure 4-5.4: The LACP System Priority page
Parameter descriptions:
System Priority: Show the System Priority part of a system ID (1-65535).
Buttons
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...