4-6.2 Status
This section displays the loop protection port status.
Web Interface
To display the Loop Protection status in the web interface:
1. Click Port Management, Loop Protection, and Status.
2. To automatically refresh the information select “Auto refresh”.
3. Click “Refresh” to refresh the Loop Protection Status.
Figure 4-6.2: Loop Protection Status
Parameter descriptions:
Port: The switch port number of the logical port.
Action: The currently configured port action (Shutdown Port, Shutdown Port and
Log, Log Only).
Transmit: The currently configured port transmit mode.
Loops: The number of loops detected on this port.
Status: The current loop protection status of the port.
Loop: Whether a loop is currently detected on the port.
Time of Last Loop: The time of the last loop event detected.
Buttons
Auto-refresh: Check to refresh the page automatically every 3 seconds.
Refresh: Click to refresh the page immediately.
To Next Page
Loading...