Chapter 5 - PoE Management
PoE (Power over Ethernet) is used to transmit electrical power to remote
devices over standard Ethernet cable. PoE can be used for powering IP
telephones, wireless LAN access points and other equipment, where it would
be difficult or expensive to connect the equipment to main power supply.
5-1 PoE Configuration
This page lets you view and configure current PoE port settings and
show PoE Supply power.
Web Interface
To configure Power over Ethernet in the web interface:
1. Click PoE Management and PoE Configuration.
2. Specify Reserved Power, Capacitor Detection, Mode, PoE Schedule, Priority, and Maximum
Power (W).
3. Click Apply to save the configuration.
4. To cancel the setting, click the Reset button to revert to previously saved values.
Figure 5-1: PoE Configuration
Parameter descriptions:
PoE Firmware Version: The firmware version of the PoE chip/circuit (e.g., 161). This is different than
the device FW version from the System > System Information > Firmware Version menu path.
Primary Power Supply [W]: Displays the primary power supply power in watts (e.g., 130 Watts).
To Next Page
Loading...