Transition Networks SM8TAT2SA - Poe Power Delay

5-3 PoE Power Delay
This page lets you specify how much time the switch will wait before it provides power to a
specified port after the switch reboots.
Web Interface
To configure Power over Ethernet Power Delay in the web interface:
1. Click PoE Management and PoE Power Delay.
2. Enable or Disable Delay Mode.
3. Specify the Delay Time.
4. Click Apply to apply the change.
Figure 5-3: PoE Power Delay
Parameter descriptions:
Port: The port being configured; each port instance is represented by a line in the table.
Delay Mode: At the dropdown, select Enabled. The default is Disabled.
Delay Time(0~300 sec): Enter the amount of delay time (0~300 seconds). The default is 0 seconds.
If Port 1 PoE Power Delay time setting is 30 seconds, it means the switch will wait 30 seconds to provide
power to port 1 after the switch reboots.
Buttons
Apply : Click to save changes.
Reset : Click to undo any changes made locally and revert to previously saved values.