6-8 Private VLAN
The Private VLAN membership configurations for the switch can be monitored and modified
here. Private VLANs can be added or deleted here. Port members of each Private VLAN can be
added or removed here.
Private VLANs are based on the source port mask, and there are no connections to VLANs.
This means that VLAN IDs and Private VLAN IDs can be identical.
A port must be a member of both a VLAN and a Private VLAN to be able to forward packets.
By default, all ports are VLAN unaware and members of VLAN 1 and Private VLAN 1.
A VLAN unaware port can only be a member of one VLAN, but it can be a member of multiple
Private VLANs.
Web Interface
To configure Port Isolation configuration in the web interface:
1. Click VLAN Management and Private VLAN.
2. Configure the Private VLAN membership configurations for the switch.
3. Click the Apply button.
Figure 6-4: Private VLAN Membership Configuration
Parameter descriptions:
Delete: To delete a private VLAN entry, check this box. The entry will be deleted during the next apply.
PVLAN ID: Indicates the ID of this particular private VLAN.
Port Members: A row of check boxes for each port is displayed for each private VLAN ID. To include a
port in a Private VLAN, check the box. To remove or exclude the port from the Private VLAN, make sure
the box is unchecked. By default, no ports are members, and all boxes are unchecked.
Adding New Private VLAN: Click the Add New Entry button to add a new private VLAN ID. An empty
row is added to the table, and the private VLAN can be configured as needed.
The Private VLAN is enabled when you click "Apply". The Reset button can be used to undo the
addition of new Private VLANs.
Buttons
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...