7-3 Port Policing
This section provides an overview of QoS Ingress Port Policers for all switch ports. Port Policing
is useful in constraining traffic flows and marking frames above specific rates. Policing is
primarily useful for data flows and voice or video flows because voice and video usually
maintains a steady rate of traffic.
Web Interface
To configure the QoS Port Policers in the web interface:
1. Click Quality of Service and Port Policing.
2. Click which port need to enable the QoS Ingress Port Policers, and configure the Rate
limit condition.
3. Click Apply to save the configuration.
4. To cancel the setting, click the Reset button to revert to previously saved values.
Figure 7-3: The QoS Ingress Port Policers page
Parameter descriptions:
Port: The logical port for the settings contained in the same row. Click on the port number to configure
its schedulers.
Enable: Check to enable for each Port you on which you want to enable the QoS Ingress Port Policers
function.
Rate (kbps): To set the Rate limit value for this port, the default is 1000000 kbps.
Buttons
Apply : Click to save changes.
Reset : Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...