(Attach to back wire on motor, or to vehicle metal frame/bumper)
Transmitter
Disconnect power before installation.
” Unlock/disengage winch clutch before installation & testing.
Operation:
Unloc k/disengage winch clutch.
Pull out winch wire/ro pe about 5 ft. ” Loc k/engage winch clutch.
Press the button, now you may operate winch (Power In or Out)
Turn off power when not use.
Warning:
Changes or modifications to this unit not expressly app roved by the party responsib Ie for compliance could
void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC
These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or tele vision reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
To Next Page
Loading...