Traxxas Aton - Assembly Instructions Manual

Kit contents:
• Upper mount half
• Lower mount half
• Rubber isolators for fixed camera bracket mount assembly (4)
• Rubber isolators for 2-axis gimbal mount assembly (4) (marked with yellow dot)
Tools required:
• Needle nose pliers
TRAXXAS.com
Traxxas, 6250 Traxxas Way, McKinney, TX 75070, Phone: 972-549-3000, Fax: 972-549-3011, e-mail: support@Traxxas.com
KC2361-R01 Rev 151222
Mount Assembly for use with fixed camera bracket
Covers Part #7971
Camera/Gimbal Mount Assembly Instructions
Mount Assembly for use with 2-axis gimbal
Mount Assembly
1. Slide the upper mount half under the lower mount half (A).
2. Flex the upper mount half to align the eyelets above the lower mount half eyelets on
each corner of the mount (B). Refer to Figure B for the order of eyelet alignment (1-4).
3. Use needle nose pliers to install the rubber isolators into the eyelets on each corner
between the two mount halves (C).
A B
C
A B
C
1
2
3
4
1
2
3
4
Final Assembly
Final Assembly