TRENDnet TEW-740APBO2K User Manual

© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO / TEW-740APBO2K
32
SNMP v3
1. Log into your access point management page (see “Access your access point
management page” on page 28).
2. Click System and click on SNMP. Review the settings and click Save to apply the
changes.
 Active – Enable or disable SNMP version 3.
 RO Username – Enter the read only user name.
 RO Password – Enter the read only password.
 RW Username – Enter the read/write user name.
 RW Password – Enter the read/write password.
SNMP Trap
1. Log into your access point management page (see “Access your access point
management page” on page 28).
2. Click System and click on SNMP. Review the settings and click Save to apply the
changes.
 Active – Enable or disable SNMP Trap.
 Community – Enter the community name for SNMP trap.
 IP 1 – Enter the IP address of the 1
st
SNMP trap receiver.
 IP 2 – Enter the IP address of the additional SNMP trap receiver.
 IP 1 – Enter the IP address of the additional SNMP trap receiver.
 IP 1 – Enter the IP address of the additional SNMP trap receiver.

TRENDnet TEW-740APBO2K Specifications

General

Brand	TRENDnet
Model	TEW-740APBO2K
Category	Wireless Access Point
Language	English