© Copyright 2015 TRENDnet. All Rights Reserved.
Turn the router off disconnect the power adapter from the rear panel of your
router for 10 seconds and reconnect the power adapter, see “Product Hardware
Features” on page 2 .
Use this method if you are encountering difficulties with accessing your router
management page. This is also known as a hard reboot or power cycle.
OR
Router Management Page: This is also known as a soft reboot or restart.
1. Log into your management page (see “Access the management page” on page 16).
2. Click on the Management tab and click Backup/Restore Settings.
3. Click Reboot to restart the router. If prompted, click yes or OK.
Upgrade your firmware
Maintenance > FW Upgrade
TRENDnet may periodically release firmware upgrades that may add features or fix
problems associated with your TRENDnet router model and version. To check if there is
a firmware upgrade available for your device, please check your TRENDnet model and
version using the link. http://www.trendnet.com/downloads/
In addition, it is also important to verify if the latest firmware version is newer than the
one your router is currently running. To identify the firmware that is currently loaded on
your router, log in to the router, and check the version located at the top right of the
router management page. If there is a newer version available, also review the release
notes to check if there were any new features you may want or if any problems were
fixed that you may have been experiencing.
1. If a firmware upgrade is available, download the firmware to your computer.
2. Unzip the file to a folder on your computer.
Please note the following:
Do not interrupt the firmware upgrade process. Do not turn off the device or press
the Reset button during the upgrade.
If you are upgrade the firmware using a laptop computer, ensure that the laptop is
connected to a power source or ensure that the battery is fully charged.
Disable sleep mode on your computer as this may interrupt the firmware upgrade
process.
Do not upgrade the firmware using a wireless connection, only using a wired
network connection.
Any interruptions during the firmware upgrade process may permanently damage
your router.
1. Log into your router management page (see “Access your router management page”
on page 22).
Note: You can check your router’s current firmware version at the top right of the
page.
2. Click on Maintenance, and click on FW Upgrade.
Note: This page also displays the current firmware version of your router.
3. Depending on your web browser, next to Upgrade Firmware, click Browse or Choose
File.
4. Navigate to the folder on your computer where the unzipped firmware file (.bin) is
located and select it.
5. Click Upgrade to start the firmware upgrade process. If prompted, click yes or OK.
To Next Page
Loading...
Need help?
General
