© Copyright 2015 TRENDnet. All Rights Reserved.
Software Controller utility
Installation
1. Insert the CD ROM included with the access point.
2. Click on Software controller to install the utility.
3. Once the utility is installed click on Discover to refresh the list of access points.
4. Select the access point you want to configure.
5. Click on Device settings to configure the access point.
Add and Delete Device
Add device
1. Run the utility
2. To add a device to control select the “+” on the upper right corner
3. Enter the IP address of the device you would like to add to the controller and press
OK.
To Next Page
Loading...
Need help?
General
