Specifications:
• Bluetooth Version: V5.3
• Output Power: 25W
• Bluetooth Protocol: A2DP, AVRCP, HFP, HSP
• Frequency Response Range: 50~20KHz
• Frequency Band Range: 2402-2480MHZ
• Maximum Transmission Power: ≤6dBm
• Battery: 5200mAh
• Play Time: 30 hours (At 60% volume with XBass off)
• Charging Time: About 4 hours
• Waterproofing Grade: IP67
• Size: 201mm x 90.40mm x 52.40mm
• Weight: 660g
FCC Statement:
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This equipment has been tested
and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These mits are designed to provide reasonable protection against harmful nterference
in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
— Reorient or relocate the receiving antenna.
-- Increasetheseparationbetweentheequipmentand receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected. — Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions (l)this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
IC Caution:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) This device may not cause interference, and (2)
This device must accept any interference, including interference that may cause undesired
operation of the device.
To Next Page
Loading...
