TRICKSTUFF® GMBH
SCHWABENMATTEN 17A
79292 PFAFFENWEILER
GERMANY
TECH-SUPPORT@TRICKSTUFF.DE SERVICE MANUAL – PICCOLA PUMP V2024_02. PAGE 15 OF 25
6. Unscrew the M2-bolt from the reservoir cap using a TX6 key. Take off the cap, remove the
membrane and discard it. Soak up leaking oil with a shop towel.
7. Clean pump housing and reservoir cap with warm water and a liberal amount of washing-up
liquid. Works best in combination with a soft brush and a lot of clean water for rinsing
afterwards. Before assembly, make sure everything is properly dried and no water residue
remains. You can dry the pump with compressed air or by putting it on a household radiator
for some time.
8. Use a flashlight to check the cylinder surface for cleanliness, scratches and possible
damage/debris. If you find your cylinder surface damaged, please contact the Trickstuff
Tech-Support.
To Next Page
Loading...
Need help?
General
