STEP 7: Install the rear wheel , fasten it with quick release
STEP 8: Tak e th e se at cl ot h an d a tt a ch it to the se at fra me . I t is su ppo se d t o fi t tig ht . As
you sit on the seat- it will stretch. First attach the top of the seat cover to the seat. Next
attach 1 lower corner. For the remaining lower corner, turn the seat cover inside out at that
corner and stretch it over the last corner and flip it back right side out. Next tighten the
Velcro straps. You can start from Number 4 strip from bottom, then No.3 from bottom, then
adjust each one to give you as much or as little support as you like. Sometimes these
straps are very tight and you have to pull hard to attach them. The hardest part is at the
lower bend- make sure you work the sides of the cover over the seat frame as you pull the
straps.
To Next Page
Loading...