58
USING THE Viper TRIDENT ALL PURPOSE METAL DETEC-
TOR —
LOWEST
AUDIO
PITCH
LOWEST
AUDIO
PITCH
HIGHEST AUDIO PITCH
(Dead Center)
The Viper TRIDENT is a slow motion type detector, in other words
the coil must be in slow motion to respond to any target. By sim-
ply moving the coil back and forth over the ground this motion will
activate the automatic ground balance and tuning circuits of you
detector and keep it at its optimum tuning levels. When scanning
the ground try to keep the search coil about 1 inch off the ground.
DO NOT scrub the ground, you may get some "False Signals" by
doing that. Please refer to the following drawings for the correct way
to sweep and hold your metal detector.
2
FEET
PER
SECOND
Simply moving
the coil back
and forth over
the ground.
Keep the search
coil about 1 inch
off the ground.
OPERATION OF CONTROLS —
To operate and turn on the Viper T
RIDENT simply turn the power ON/
OFF knob in a clockwise direction.
After you have turned on the Viper T
RIDENT you should now adjust
the SENS Control to Pre-set position. This is only a starting point
and will help you get familiar with your new Viper T
RIDENT All Pur-
pose detector.
Power ON and OFF
SENS Control
POWER
ON/OFF
To Next Page
Loading...