© 2020 TRINITY - 800.985.5506
3
STEP 4
ASSEMBLY INSTRUCTIONS
STEP 3
C (1)
C
A
B
A
C
B (4)
Place SHELF (C) on its side and slide each BOTTOM
POLE (A) through each corner cylinder of SHELF (C).
Make sure LOCKING CASTERS (I) are on same side
and make sure corner cylinders are positioned over
SLIP SLEEVES (H).
Slowly stand unit upright.
Note:
Level side of SHELF (C) is TOP side (TRINITY logo on
the corner cylinders should be right-side up).
Use a rubber mallet, if needed, to secure SHELF (C).
Screw TOP POLES (B) into BOTTOM
POLES (A) in clockwise direction.
Note:
Top of each TOP POLE (B) is
indicated by a BLACK END CAP.
Pole Connectors are pre-installed in
bottom of TOP POLES (B).
To Next Page
Loading...
Need help?
General
