Uncrating
Installation
6
1 - Start by removing the header assem-
bly from the seat.
2- Remove the header support
3- Remove the back legs holder
4-Pull the seat out of the cabinet about 6’’
or 15cm. Then pull the 3 cables out of the
hole one by one as shown in the picture
below.
5- Remove seat assembly from the crate.
6- Remove cabinet from the crate and
move in the desired final location.
- Locate the hardware box inside of the
coin door
- You will find a description of the hard-
ware on the bag.
To Next Page
Loading...