Tripp Lite B051-000-AC - Rack Mounting Safety Instructions

4
Hardware Setup continued
Rack Mounting Safety Instructions
•Beforeworkingontherack,makesurethatthestabilizersaresecuredtotherack,extendedtotheoor,andthatthefullweightofthe
rackrestsontheoor.Installfrontandsidestabilizersonasinglerackorfrontstabilizersforjoinedmultipleracks before working on the
rack.
•Alwaysloadtherackfromthebottomup,andloadtheheaviestitemintherackrst.
•Makesurethattherackislevelandstablebeforeextendingadevicefromtherack.
•Usecautionwhenpressingthedevicerailreleaselatchesandslidingadeviceintooroutofarack;thesliderailscanpinchyourngers.
•Afteradeviceisinsertedintotherack,carefullyextendtherailintoalockingposition,andthenslidethedeviceintotherack.
•DonotoverloadtheACsupplybranchcircuitthatprovidespowertotherack.Thetotalrackloadshouldnotexceed80percentofthe
branch circuit rating.
•Makesurethatallequipmentusedontherack,includingpowerstripsandotherelectricalconnectors,isproperlygrounded.
•Ensurethatproperairowisprovidedfordevicesintherack.
•Ensurethattheoperatingambienttemperatureoftherackenvironmentdoesnotexceedthemaximumambienttemperaturespecied
for the equipment by the manufacturer.
•Donotsteponorstandonanydevicewhenservicingotherdevicesinarack.
TheB051-000-ACcanbeplacedonanylevelsurfacethatcansafelysupportitsweightplustheweightofattachedcables.Whenplacing
the unit on a desktop, remove the backing material from the rubber feet that came with this package and affix them to the bottom panel
at the corners.
Note: To ensure adequate ventilation, allow at least 5 cm on each side, and 13 cm at the back for power cord and cable clearance.
Stacking
12-176 93-3159_RevC.indd 4 8/27/2012 2:48:15 PM