Tripp Lite B130-101 - Page 13

13
3
Connect the external power supply to the transmitter unit and plug it
into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS).
4
Wait 10 seconds for the EDID information to be copied, and then
disconnect the monitor from the transmitter unit’s input port and
proceed per the installation instructions in this manual.
5
YoucanverifythattheEDIDinformationwascopiedviatheDisplay
Settings screen in your computer. If the model name of the monitor
that you copied is shown in the Display field of the screen, the EDID
information has been copied successfully.
Installation continued
13-04-119-93-3289.indd 13 4/26/2013 2:00:23 PM