Tripp Lite B132-002A-2 - Page 23

23
Installation continued
If you are not connecting additional remote repeater units, proceed to
step 11 to complete the chain with a receiver unit.
8
UsingCat5e/6cable,connecttheRJ45OUTPUT port on the first
remoterepeaterunittotheRJ45INPUT port on a second remote
repeater unit.
9
Ontheremoterepeaterunitthatyoujustadded,connectamonitor
and speakers* to the OUTPUT port(s) using a VGA video and audio*
cable.
10
Connect the external power supply to the remote repeater unit, and
then plug it into a Tripp Lite Surge Suppressor, Power Distribution Unit
(PDU) or Uninterruptible Power Supply (UPS). The Red power LED and
theGreenRJ45LEDwillilluminatetoindicatetheunitisreceiving
power.
If you are not connecting additional remote repeater units, proceed to
step 11 to complete the chain with a receiver unit. If you are connecting
another remote repeater unit, repeat steps 8 through 10.
11
UsingCat5e/6cable,connecttheRJ45OUTPUT port on the last
remoterepeaterunittotheRJ45INPUTportonareceiverunit.
Note: If you have a B130-101-2 or B130-101A-2 extender kit, you will use the
included receiver unit. The B130-111 and B130-111A extender kits require a
receiver unit to be purchased separately.
12
Connect a monitor and speakers* to the OUTPUT port(s) on the
receiver unit using a VGA video and audio* cable.
13
Connect the external power supply to the receiver unit, and then plug
it into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS).
14
Turn on the power to the connected monitors and speakers*.
15
Turn on the power to the VGA video and audio* source. The Orange
RJ45LEDswillilluminatetoindicatethattheunitsarereceivinga
signal from the source.
16
Ifnecessary,usetheincludedscrewdrivertoadjusttheEqualization
and Gain settings on the remote repeater and receiver units to
improve the video image.
*If this is a feature of your extender kit.
13-04-119-93-3289.indd 23 4/26/2013 2:00:24 PM