Tripp Lite B132-002A-2 - Page 30

30
Installation continued
12
UsingCat5e/6cable,connecttheRJ45OUTPUT port on the last
remoterepeaterunittotheRJ45INPUT port on a receiver unit.
13
Connect a monitor and speakers* to the OUTPUT port(s) on the
receiver unit using a VGA video and audio* cable.
14
Connect the external power supply to the receiver unit, and then plug
it into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS).
Repeatsteps6through14foreachadditionalRJ45OUTPUT port on
each of the transmitter units, and then proceed to step 15.
15
Turn on the power to the connected monitors and speakers*.
16
Turn on the power to the VGA video and audio* source. The Orange
RJ45LEDswillilluminatetoindicatethattheunitsarereceivinga
signal from the source.
17
Ifnecessary,usetheincludedscrewdrivertoadjusttheEqualization
and Gain settings on the remote repeater and receiver units to
improve the video image.
*If this is a feature of your extender kit.
13-04-119-93-3289.indd 30 4/26/2013 2:00:26 PM