14
RS-232 Commands
Commands for Serial Control
Command Meaning
Sw1 x1 Routed to Output1, Output n to input [x1]
Sw2 x1 Routed to Output1, Output n to input [x1]
Sw3 x1 Routed to Output1, Output n to input [x1]
Sw4 x1 Routed to Output1, Output n to input [x1]
PWD Stands for Power On/Off
STE State of the output
Important note control command:
Only one command can be issued at a time. You must wait for the switch to
accept and finish the first command before sending a second. If a second
command is sent/issued before the first is completed, the switch will ignore the
second command.
Installation
20-05-301-93-3C5E.indd 1420-05-301-93-3C5E.indd 14 6/2/2020 11:36:45 AM6/2/2020 11:36:45 AM
To Next Page
Loading...
Need help?
General
