5
1b. Solid Brick and Concrete Mounting
Find and mark the
exact location of
mounting holes
Fasten the wall
plate onto the
wall
Drill pilot holes
WARNING
• When installing wall mounts on cinder block, verify the actual concrete thickness
is at least 1-3/8” (35mm) for using the concrete anchors. Do not drill into mortar
joints! Be sure to mount in a solid part of the block, generally 1” (25mm) minimum
from the side of the block. It is suggested an electric drill on a slow setting be used
to drill the hole instead of a hammer drill to avoid breaking out the back of the hole
when entering a void or cavity.
• Installers must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
Concrete Anchor
D8 Washer
Anchor Bolt
14-11-076-9333E1.indd 5 11/12/2014 3:40:46 PM
To Next Page
Loading...
