To Next PageTo Next Page
Need help?Do you have a question about the Tripp Lite OmniPro500 and is the answer not in the manual?
General| Power Rating | 500 VA / 300 W |
|---|---|
| Output Power | 300 W |
| Input Voltage | 120 V |
| Output Voltage | 120 V |
| Number of Outlets | 6 |
| Form Factor | Tower |
| Input Frequency | 60 Hz |
| Input Connection Type | NEMA 5-15P |
| Typical Recharge Time | 8 hours |
| Dimensions | 10 x 7 x 12 inches |
| Weight | 20 lbs |
| Frequency | 60 Hz |
| Waveform | Stepped Sine Wave |
| Battery Recharge Time | 8 hours |
| Battery Type | Sealed Lead Acid (SLA) |
| Data Line Protection | RJ11 |
| Communication Ports | USB |
| Output Voltage Regulation (Battery Mode) | ± 5% |
Instructions for placing the UPS indoors, away from heat, dust, and direct sunlight, and maintaining temperature.
Guidance on connecting the UPS to a grounded AC outlet and avoiding self-connection or generator use without proper output.
Advisories against using UPS for life support and connecting surge suppressors to the UPS output.
Information on battery maintenance, replacement by qualified personnel, and proper recycling or disposal.
Details on using telephone cords to connect wall jacks and equipment to the UPS for surge protection.
Instructions on setting the UPS's 'OFF-ON' switch for operation or standby, with a warning about backup during 'OFF' state.
Explanation of the 'ON' and 'OFF' positions of the main UPS switch and their functions.
How to use the momentary switch to silence alarms, test battery charge, and perform a cold start.
Description of standard and surge-only AC outlets on the UPS for connecting equipment.
Details on telephone line surge protection jacks and their optional connectivity.
Information about the battery replacement door and the need for qualified service personnel.
Instructions for storing the UPS, including recharging frequency to prevent battery capacity loss.
Procedures for returning the UPS for service, including packing and documentation requirements.
