What to do if my Triton Saw has no function when the ON/OFF Switch is operated?
If your Triton Saw isn't turning on when you use the ON/OFF switch, first check that it's getting power. If there's a power overload, press the Circuit Breaker Reset Button (19) and try the switch again. If it still doesn't work, the ON/OFF Switch might be defective and needs replacing at an authorised Triton service centre.
Why are the cutting profiles inconsistent with measurements on my Triton Saw?
If you find that your cutting profiles are inconsistent with measurements on your Triton Saw, it could be that the Supporting Protractor Gauge (48) or Rip Fence (58) aren't fastened tightly enough. Make sure to refasten them securely, ensuring they don't move when you apply pressure. Another cause could be that the Saw Blade (8) is not calibrated. If so, calibrate the Saw Blade using the method described under ‘Blade calibration’. Also, the sacrificial wood on the Protractor Gauge (48) might not be providing enough support, in which case you should replace the sacrificial wood piece.
Why is the bevel angle setting loose on my Triton Saw?
If the bevel angle setting on your Triton Saw feels loose, it's likely that the Bevel Angle Locking Lever (4) isn't properly engaged. Make sure to lock the Bevel Angle Locking Lever.
How to fix a stiff Blade Height Winder on a Triton Saw?
If you're finding it hard to wind the Saw Blade (8) up or down on your Triton Saw and the Winder feels stiff, the Blade Height Lock (3) might be engaged. Disengage the Blade Height Lock, then wind the Blade Height Winder (1). Remember to re-engage the lock once you've reached the desired blade height.
Warnings related to the use and maintenance of safety guards.
Warnings and best practices for safe cutting operations.
Tips to prevent the saw blade from overheating during use.
Instructions for safely unpacking and inspecting the tool.
Procedures for installing, removing, and levelling the saw module.
Step-by-step guide for installing the riving knife.
Procedure for calibrating the saw blade angle and position.
Specific steps for installing the anti-kickback components.
Specific steps for installing the blade guard assembly.
How to power the tool on and off safely.
Steps to adjust and use the protractor gauge for angle cuts.
Instructions for making cross cuts.
Instructions for making rip cuts.
How to perform regular checks on the tool.
Procedure for safely replacing the saw blade.
To Next Page
General