Triumph Protect+ User Manual

9 of 9
To Adjust the Passive Arming Time
1. Disarm the Triumph Protect+.
2. Turn on the ignition.
3. Within 10 seconds, press and hold both buttons
on the remote control.
4. After 3 seconds the Triumph Protect+ will start
to chirp. Release the remote control buttons
after three chirps. The Triumph Protect+ will
bleep a specified number of times to indicate
the current setting.
5. Press the Arm/Disarm button on the remote
control to cycle through the automatic arming
options:
• Off (1 Bleep).
• 30 second delay (2 Bleeps).
• 60 second delay (3 Bleeps).
• 120 second delay (4 Bleeps).
6. Turn off the ignition to exit programming and
save the new setting.
To Choose the Motorcycle Battery type
1. Disarm the Triumph Protect+.
2. Turn on the ignition.
3. Within 10 seconds, press and hold both buttons
on the remote control.
4. After 3 seconds the Triumph Protect+ will start
to chirp. Release the remote control buttons
after four chirps. The Triumph Protect+ will
bleep a specified number of times to indicate
the current setting.
5. Press the Arm/Disarm button on the remote
control to cycle through the motorcycle
battery options:
• Lead Acid (1 Bleep).
• Lithium (2 Bleeps).
6. Turn off the ignition to exit programming and
save the new setting.
To Reset the Triumph Protect+ to the Default
Settings
1. Disarm the Triumph Protect+.
2. Turn on the ignition.
3. Within 10 seconds, press and hold both buttons
on the remote control.
4. After 3 seconds the Triumph Protect+ will start
to chirp. Release the remote control buttons
after five chirps.
5. Press the Arm/Disarm button on the remote
control once, the Triumph Protect+ will bleep
twice.
6. Press both buttons on the remote control to
save the default settings and exit
programming.
To Add a new Remote control
1. Disarm the Triumph Protect+.
2. Turn on the ignition.
3. Within 10 seconds, press and hold both buttons
on the remote control.
4. After 3 seconds the Triumph Protect+ will start
to chirp. Release the remote control buttons
after six chirps. The Triumph Protect+ will bleep
once.
5. Press the Arm/Disarm button, the Triumph
Protect+ will bleep twice.
6. Press both buttons together on the remote
control, the Triumph Protect+ will bleep twice.
Note:
• After programming the first remote control all
other remote controls will be deleted.
7. Press either button on the first remote control
to be added, the Triumph Protect+ will bleep
once.
8. Press either button on the next remote control
to be added, the Triumph Protect+ will bleep
once. Repeat the step for all additional remote
controls to be added, (maximum 6). The remote
control LED will flash to show the number of
remote controls programmed.
9. Press the Arm/Disarm button once, the alarm
will bleep once.
10. Turn off the ignition to exit programming and
save the new settings.

Triumph Protect+ Specifications

General

Brand	Triumph
Model	Protect+
Category	Security System
Language	English