Triumph Rocket 3 GT 2021 - Page 1036

998
1
For models with a front brake master cylinder bleed screw only.
Front Brake Lever Setting
NOTICE
Note the original setting of the brake lever adjuster in order that it can be returned to
the same position when the bleeding operation is complete.
1. Turn the brake lever adjuster fully in to give maximum lever span.
1. Brake lever
2. Adjusting screw
Master Cylinder Back Bleed (Radial Master Cylinder)
During bleeding, do not allow the brake fluid level to fall below the lower level mark in
the reservoir.
If the fluid level is allowed to fall below this mark, air may enter the system and the
sequence of bleeding must be repeated.