1001
Front Brake Master Cylinder Bleed
1. Slowly apply then slowly release pressure to the brake lever five times, maintaining
pressure on the final application.
2. Open the bleed screw slightly.
3. Close the bleed screw once the lever has come to a stop against the handlebar.
1. Bleed screw
2. Fluid reservoir
4. Slowly apply and slowly release pressure to the brake lever another five times,
maintaining pressure on the final application.
5. Open the bleed screw slightly to allow fluid to flow out but to still feel resistance in
the brake lever.
6. Leave the bleed screw slightly open and slowly release the brake lever.
7. Slowly apply and release pressure to the brake lever another five times, closing the
bleed screw on the final application.
8. Repeat steps 4 to 10 until no more air appears from the bleed screw.
9. With the brake lever still applied, tighten the master cylinder bleed screw to 6 Nm.
10. Fill the reservoir to the upper level with new DOT 4 fluid.
Front Brake Caliper(s) Bleed
1. Remove the rubber cap from the caliper bleed screw.
2. Attach a transparent tube to the bleed screw.
To Next Page