Brake fluid is hygroscopic which means it will absorb moisture from the air.
Only use new DOT 4 brake fluid from a sealed container, do not mix different brands
of brake fluid and never use brake fluid from an unsealed container or from one that
has been previously opened.
Any absorbed moisture will greatly reduce the boiling point of the brake fluid.
Moisture in the braking system may a cause a reduction in braking efficiency leading
to loss of motorcycle control and an accident.
Do not allow dirt or debris to enter the braking system when adding brake fluid to the
brake fluid reservoir
Always maintain absolute cleanliness as this will adversely affect the brake fluid's
properties.
Contaminated brake fluid may cause a reduction in brake performance leading to loss
of motorcycle control and an accident.
During bleeding, do not allow the brake fluid level to fall below the lower level mark in
the reservoir.
If the fluid level is allowed to fall below this mark, air may enter the system and the
sequence of bleeding must be repeated.
Trapped air in the braking system may a cause a reduction in braking efficiency
leading to loss of motorcycle control and an accident.
To Next Page
Loading...
