Triumph Rocket 3 GT 2021 - Page 1052

1014
3. Place the other end of the tube in a suitable container containing new brake fluid.
1. Bleed screw
2. Bleed tube
NOTICE
The bleed screw should only be opened by a small angle, just enough to allow system
pressure to drop. When pulling the brake lever or pushing the caliper pistons in, some
resistance should be felt indicating that the screw is not opened too much.
4. Slowly apply and slowly release pressure to the brake pedal five times, maintaining
pressure on the final application.
5. Counter hold the brake hose union bolt and open the bleed screw slightly to allow
fluid to flow out but to still feel resistance in the brake pedal.
6. Slowly apply and slowly release pressure to the brake pedal until the brake fluid in
the reservoir reduces down to the MIN level, maintaining pressure on the final
application.
7. Close the bleed screw.
8. Top up the brake fluid in the reservoir to the MAX level.
9. Slowly apply and slowly release pressure to the brake pedal five times, maintaining
pressure on the final application.
10. Counter hold the brake hose union bolt and open the bleed screw slightly to allow
fluid to flow out but to still feel resistance in the brake pedal.