Triumph Rocket 3 GT 2021 - Page 1069

1031
Diagnostic Trouble Codes
Dependant on the DTC stored, the ABS ECM will act in one of two ways:
1. Inhibit ABS operation immediately, irrespective of the ABS operating mode;
or
2. Allow the ABS operation to complete before inhibiting the ABS.
Once the ABS ECM has inhibited ABS function, the ECM will act in one of three ways:
1. Allow the ABS to resume operation if the fault clears;
or
2. Allow ABS operation after an ignition cycle if the fault clears;
or
3. Inhibit the ABS function until the fault is rectified and the DTC erased. The ABS
system will act on the DTC stored according to the table:
NOTICE
ABS is Active means that the ABS system is completing an ABS manoeuvre.
ABS Electrical Connectors
Before beginning any diagnosis, the following connector related information should be
noted:
NOTICE
A major cause of hidden electrical faults can be traced to faulty electrical connectors.
For example:
• Dirty/corroded terminals
• Damp terminals
• Broken or bent cable pins within multiplugs.