Triumph Rocket 3 GT 2021 - Page 1137

1099
2. Using a suitable a flat metal plate approximately 2 mm thick and 30 to 50 mm wide
(for example a gasket scraper) between the brake pads, pump the rear brake pedal
until the plate is held by the brake pads.
NOTICE
Note the bleed screw is fitted to the rear brake hose union.
Note the position and orientation of the anti-rotation spacer at the caliper for
installation.
Note the orientation of the rear brake hose at the caliper for installation.
3. Disconnect the brake hose at the caliper and place the free end of the hose in a
suitable container to collect the brake fluid.
4. Collect the anti-rotation spacer and discard the three sealing washers.
1. Brake hose union
2. Sealing washers
3. Brake hose
4. Anti-rotation spacer