Do not allow the wheel to rest on the brake disc as this may damage the disc leading
to loss of motorcycle control and an accident.
To prevent wheel and wheel bearing damage, ensure dirt and debris are not allowed
to enter the wheel bearings.
6. Place the wheel on wooden blocks to prevent damage to the brake discs.
7. Thoroughly clean all components and inspect for wear or damage.
Front Wheel – Installation
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
1. Lightly smear the spacers with grease and locate into the left hand and right hand
sides of the hub.
1. Spacer (right hand shown)
To Next Page
Loading...
