1177
8. Fit the licence plate hanger to the bevel box and tighten its fixings to 20 Nm.
1. Fixings
2. Licence plate hanger
9. Thoroughly clean the threaded fixing holes for the brake caliper fixings.
10. Thoroughly clean the threaded part of the fixings and smear the first four threads
with a proprietary copper based grease.
11. Position the caliper over the disc.
12. Secure the brake caliper with the fixings and tighten sufficiently to bring the caliper
into contact its mounting points, while allowing a small amount of lateral movement.
Do not fully tighten at this stage.
13. Pump the brake pedal to correctly position the caliper pistons.
To Next Page
Loading...
