1338
Keyless Ignition Anti-Tamper Strategy Activated
Keyless ignition anti-
tamper strategy
activated
Repeated attempts to
turn the Ignition ON
without a paired key in
range
Wait at least three minutes after the last
attempt to turn the ignition ON
Erase DTC
Refresh the Read DTCs screen and make sure
that C1151 is not re-triggered
Make sure a paired key is in range of the LF
antenna when turning the ignition ON
If the ignition turns ON, no further action
required
If the ignition does not turn ON, check C1151
has not been re- triggered
Right Hand Switch Housing Malfunction
Right hand switch housing
malfunction - Engine start/stop
switch correlation fault
Disconnect right hand switch housing,
engine ECM connector B and Keyless ECM
and proceed to pinpoint test 1:
CAN fault-lost communication
with engine ECM
Refer to CAN fault - lost communication
with engine ECM (see Engine ECM
Communication (CAN))