A suitable safe place should be found to carry out the road test.
The Transmission Warning symbol is illuminated on the instrument display.
3. Road test the motorcycle as follows:
• Ride the motorcycle smoothly at low engine speeds, changing up through each
gear in turn.
• Fully close the throttle and use the clutch at each gear change.
• As soon as each gear engages, allow the gear change pedal to return to its
normal resting position. Do not rest your foot on the pedal as any movement of
the pedal can cause incorrect adaption.
• When each gear change is complete, release the clutch and ride normally using
gentle acceleration. Avoid rapid acceleration or deceleration as this will prevent
adaption.
• The gear position will adapt a few seconds after each gear change is completed.
• When all gear positions have successfully adapted, the Transmission Warning
symbol will turn off.
• After completing the road test, turn the ignition OFF for at least 60 seconds to
allow the adaption settings to be stored in ECM memory.
• The gear position adaption status can be confirmed using the Triumph diagnostic
tool.
To Previous Page
Loading...
