153
4. Turn the crankshaft anticlockwise 360 degrees until the two gear teeth with an
alignment mark on each is visible in the hole for the crankshaft locking pin.
1. Crankshaft primary gear
2. Alignment marks
5. Check that the camshafts alignment marks on the sprocket end of the camshaft are
pointing inwards. If they are pointing outwards, turn the crankshaft anticlockwise 360
degrees until the two gear teeth with an alignment mark on each is visible in the hole
for the crankshaft locking pin.
The alignment mark on the flange of T3880501 - Crankshaft Locking Pin is in line with
the gear tooth at the other end of the service tool. Use this alignment mark as a guide
when inserting the service tool.
To Next Page
Loading...
