251
13. Remove the cable tie or rubber band from the slave cylinder.
14. Fit a new gasket to the clutch slave cylinder.
15. Fit the slave cylinder to the clutch cover ensuring that the lifter piece locates correctly
in the cylinder. Tighten the cylinder to clutch cover bolts to 10 Nm.
1. Fixings
2. Clutch slave cylinder
16. Check the clutch for correct operation and fluid leaks. Rectify as necessary.
17. Fit the clutch cover finisher and secure with the single fixing as noted for removal. Do
not fully tighten the fixing at this stage.
To Next Page
Loading...
