4
Among those acts presumed to constitute tampering are the acts listed below:
• Removal of, or puncturing the muffler, baffles, header pipes or any other
component which conducts exhaust gases.
• Removal of, or puncturing of any part of the intake system.
• Lack of proper maintenance.
• Replacing any moving parts of the vehicle, or parts of the exhaust or intake
system, with parts other than those specified by the manufacturer.
References
References to the left hand or right hand side given in this manual are made when
viewing the motorcycle from the rear.
Operations covered in this manual do not always include reference to testing the
motorcycle after repair. It is essential that work is inspected and tested after completion
and, if necessary, a road test of the motorcycle is carried out particularly where safety
related items are concerned.
Dimensions
The dimensions quoted are to design engineering specification with service limits where
applicable.
During the period of running-in from new, certain adjustments may vary from the
specification figures given in this manual. These will be reset by the dealer at the
500 mile/800 km service, and thereafter should be maintained at the figures specified in
this manual.
Repairs and Replacements
Before removal and disassembly, thoroughly clean the motorcycle. Any dirt entering the
engine or other parts will work as an abrasive and shorten the life of the motorcycle.
To Next Page
Loading...
