Triumph Rocket 3 GT 2021 - Page 465

437
3. At the front of the engine, rotate the crankshaft anticlockwise using the bolt fitted to
the end of the crankshaft until the two gear teeth with an alignment mark on each is
visible and central in the hole for the crankshaft locking pin.
1. Crankshaft primary gear
2. Alignment marks
NOTICE
The alignment mark on the flange of T3880501 - Crankshaft Locking Pin is in line with
the gear tooth at the other end of the service tool. Use this alignment mark as a guide
when inserting the service tool.
4. Insert service tool T3880501 through the hole in the crankcase. Make sure the gear
tooth on the service tool fits between the two teeth with the alignment marks.
1. T3880501 - Crankshaft
Locking Pin
2. Alignment mark