Test is aborted
immediately after clicking
Start.
Transmission is not in
neutral.
Neutral position is not
adapted.
Neutral position adaption
is in a state of error.
Check the transmission is
in neutral. Reset the neutral
position adaption. Start the
engine and allow the
neutral position to adapt.
Turn the ignition off for at
least 60 seconds before
restarting the crankshaft
position adaption test.
Test is aborted after the
engine has reached the
required temperature.
The throttle was not held
open within 60 seconds of
the engine reaching the
required temperature.
Turn the ignition off for at
least 60 seconds before
restarting the crankshaft
position adaption test.
Make sure the throttle is
held open within 60
seconds of being
instructed to do so by the
diagnostic tool.
Crank adaption failed.
Throttle was held fully
open for 10 seconds before
the diagnostic tool
displayed an instruction to
close the throttle.
Ignition was not turned off
for 60 seconds after
adapting the neutral
position.
Turn the ignition off for at
least 60 seconds before
restarting the crankshaft
position adaption test.
Crank adaption failed.
The diagnostic tool
displayed an instruction to
close the throttle at the
expected time (after the
forth engine revving cycle).
Adaption has completed
abnormally.
Mechanical fault.
Crankshaft position signal
out of range.
Crankshaft trigger wheel
out of tolerance.
Investigate potential
mechanical faults. Contact
Triumph Service.
To Next Page
Loading...
