656
Oxygen Sensor - Slow Response
Oxygen sensor circuit slow response -
bank 1 sensor 1
View and not ‘freeze-frame’ data if
available.
Disconnect engine ECM and proceed
to pinpoint test 1:
Check cable and terminal integrity:
- Oxygen sensor pin 1
- Oxygen sensor pin 2
- EMS relay pin 5
- Engine ECM pin C22
Disconnect oxygen sensor
and proceed to test 2
Rectify fault, proceed to
test 4
Check cable for short circuit:
- Engine ECM pin C22 to ground
Check sensor resistance:
- Oxygen sensor pin 3 to 4
Locate and rectify wiring
fault, proceed to test 4
Check cable continuity:
- Engine ECM pin C22 to oxygen
sensor pin 3
- Engine ECM pin A08 to oxygen
sensor pin 4
Locate and rectify wiring
fault, proceed to test 4
Reconnect harness, clear fault code
and run engine. Check adaption status.
Action complete - quit test